Rev 2.0 - 12/03/2020
Page 7 of 16
READ INSTRUCTIONS CAREFULLY BEFORE COMMENCING THIS ACTIVITY.
PROFORM Plastics Ltd
35 Foreman Road, Hamilton, New Zealand 3200
In producing this document PROFORM Plastics Ltd. has relied upon information and representations made by third party suppliers and to the extent permitted by
law PROFORM accepts no responsibility for any losses, faults or damage caused to the vehicle or accessory components that occur due to a failure to properly
follow these instructions.
VOLKSWAGEN OE STYLING BAR FITTING INSTRUCTIONS
Part # 10055955
Instruction #: 10055950
Step 1
• Instruction text here
For diagrams that less space
use two or three step instruction page master
90°
ABS
Aluminium
Aluminium
!! Do Not Drill !!
Step 1
IMPORTANT!
Take care and drill correct holes
• Place masking tape around pilot holes in aluminium frame to prevent swarf from scratching the aluminium frame.
Using pilot holes in the aluminium as a position guide, drill 19ø hole
through one layer of aluminium only!
Note : The pilot drill bit of the hole saw can pass through all layers if required - See next step
•
•
Drill Ø19mm
Drill Ø19mm
!! Do Not Drill !!
!! Do Not Drill !!
!! Do Not Drill !!
!! Do Not Drill !!
Drill Ø19mm
Through one layer only!
Drill Ø19mm
Through one layer only!
Through one layer only!
Through one layer only!
