is used for directly connecting to the remote control equipment.
“OFF” indicates DATA1 and DATA2 can only input digital signal. It is used to
connect the signal acquisition system.
Note:
When using the PPM signal, please select low power mode in order to avoid
distortion of the PPM signal and the crash of remote control equipment.SW3 can
only take effect when it is set before the transmitter power on.
SW4 is designed for debug mode.
“ON” indicates for enable the debug mode. Then the RF power amplifier will
turn off, and the RF output will be very weak. This mode is used for checking whether
the transmitting and receiving communication is normal.
“OFF” indicates for the normal mode.
Note:
SW4 can only take effect when it is set before the transmitter power on.
SW5 and SW6 are designed for select the output frequency. The frequency table
is as follow
SW5 is OFF&SW6 is OFF
435Mhz amateur bands
SW5 is OFF&SW6 is ON
445Mhz amateur bands
SW5 is ON &SW6 is OFF
455Mhz amateur bands
SW5 is ON &SW6 is ON
433Mhz ISM band
Please set the frequency according to the local law.
Note:
Changing the transmitting frequency will need the corresponding
transmitter antenna. SW5 and SW6 can only take effect before the transmitter is
power on. It is need to be rebind with the receiver again.
If you want to change the output frequency, the corresponding antenna is
needed. SW5 and SW6 would take effect when they are before the transmitter is
power on, and, the transmitter needs to be rebind with the UHF receiver.
