Buttons
Press BIND and power on the receiver, then it will move to binding mode or
copy mode.
Press SCAN, and power on the receiver, then it will move to the interference
scan mode.
Common Indicators
RF RX: When the receiver RX or TX (there is RF output under binding mode)
RF RX LED will light up.
DONE: It will light up when binding operation or F/S setting is completed.
ANT1: Light-up of ANT1 indicates the receiver choose ANT1 RF signal.
ANT2: Light-up of ANT2 indicates the receiver choose ANT2 RF signal.
Signal Strength Indicator
Note:
The scopes of the indication of RSSI and EMI signal are the same. When
indicate RSSI , the more LED lights the stronger signal is received and the
situation is better.
When indicate EMI, the more LED lights the stronger interference is
received and the environment worse.
LED1 - LED5 are all off: indicates that the input signal is less than-115dBm
LED1 lit: the input signal is -115dBm to -109dBm
LED2 lit: the input signal is -109dBm to -103dBm
LED3 lit: the input signal is -103dBm to -97dBm
LED4 lit: the input signal is-97dBm to -85dBm
LED5 lights up when the input signal exceeds -85dBm
The Calculation of RSSI Output Voltage
Y = -120 + X / 20;
Y: RSSI
Unit is dBm
