DIP Switch
SW1 is designed for RF power selecting.
“ON” indicates high-power mode, of which output power is 5W. The RF output
warning tone is do, re, mi, fa..
“OFF” indicates low-power mode, of which output power is 2W. The RF output
warning tone is do, re, mi.
Note:
There is no warning tone of do, re, mi, or do, re, mi, fa in debug mode.
When used as a hand-held transmitter, please select low-power mode. SW1 will
directly take effect when it is set before or after power on.
SW2 is designed for Failsafe setting.
“ON” indicates
disable
failsafe. Servos will remain on the last position after
losing signal.
“OFF” indicates
enable
failsafe. After losing signal, the receiver will read out
servo position data which is previously stored in the receiver.
Note:
SW2 can only take effect when it is set before the transmitter and receiver
power on.
SW3 is designed for selecting input signal.
“ON” indicates DATA1 and DATA2 can only input PPM signal. UHF transmitter
