24
SteelConnect SDI-5030 Gateway Hardware Installation Guide
Replacing SteelConnect Gateway SDI-5030 Components
Required tools
Required tools
You need the following tools and equipment to replace gateway components:
An antistatic strap. When you replace gateway components, you must wear a grounded ESD
antistatic strap to protect the hardware against electrostatic discharge. Make sure that the strap
makes skin contact prior to handling equipment.
Use a magnetic Phillips screwdriver to remove screws in the gateway. The magnetic screwdriver
ensures screws are not lost in the gateway.
Note:
You must use approved components for the gateway to function properly. Installation of unapproved
components will result in boot failure. To order components, contact Riverbed Support at https://
support.riverbed.com.
Removing and installing the bezel
Note:
The bezel that ships with your gateway might look different from the bezel in the figure.
To remove the bezel
1.
If locked, unlock the bezel.
2.
Remove the left end of the front bezel from the rack handle (
Figure 3-1
, letter A).
3.
Pull the left side of the front bezel toward you to release the latches on the right end from the rack
handle (
Figure 3-1
, letter B).
Figure 3-1. Removing the bezel
To install the bezel
1.
Insert the tab on the right end of the front bezel to the rack handle (
Figure 3-2
, letter A).
2.
Push the left end of the bezel toward the gateway until it clicks into place (
Figure 3-2
, letter B).
