Riverbed SteelConnect SDI-2030, Hardware Installation Manual

Page: 25 / 48

Replacing SteelConnect SDI-2030 and SDI-5030 Gateway Components | 25
Removing and installing the bezel
• Use a magnetic Phillips screwdriver to remove screws in the gateway. The magnetic screwdriver
ensures screws are not lost in the gateway.
Note: You must use approved components for the gateway to function properly. Installation of unapproved
components will result in boot failure. To order components, contact Riverbed Support at https://
support.riverbed.com.
Removing and installing the bezel
Note: The bezel that ships with your gateway might look different from the bezel in the
Figure 3-2
.
To remove the bezel
1. If locked, unlock the bezel.
2. Remove the left end of the front bezel from the rack handle ( Figure 3-2 , letter A).
3. Pull the left side of the front bezel toward you to release the latches on the right end from the rack
handle ( Figure 3-2 , letter B).
Figure 3-2. Removing the bezel
To install the bezel
1. Insert the tab on the right end of the front bezel to the rack handle ( Figure 3-3 , letter A).
2. Push the left end of the bezel toward the gateway until it clicks into place ( Figure 3-3 , letter B).