Replacing SteelConnect SDI-2030 and SDI-5030 Gateway Components | 27
Removing and installing the air duct
Installing the chassis cover
1. Place the top cover on the gateway and slide it toward the front of chassis until the recessed front
edge fits smoothly under the chassis edge and the locking pins are fully engaged.
Figure 3-5. Installing the cover
2. Install the two captive installation screws at the rear of the unit and then secure the screw at the top
if there is a screw.
Removing and installing the air duct
The gateway requires an air duct for proper airflow. Always operate your gateway with the air duct in
place.
Note:
You need to remove the air duct to access many internal components.
To remove and install the air duct
1. The air duct is located on top of the fans. Lift the air duct straight up to remove it from the gateway.
