1
2
Fig. 17: Oil drain screw in detail
1 M8 screw,
2 M20 screw,
To draw oil from the device, perform the following steps:
1.
If this is the first time that an oil sample is to be taken, remove
the sealing from the oil drain screw.
2.
Remove the bolt (1) using a screw spanner size 13.
3.
Screw your oil sampling set into the M8 female thread.
4.
Loosen the bolt (2) using a screw spanner size 30 and turn it,
together with the oil sampling set, through two to three complete
rotations.
è
Oil will now flow and you can take the sample.
5.
When you have drawn sufficient oil, screw the bolt (2) back in,
together with the oil sampling set.
6.
Remove the oil sampling set.
7.
Tighten the bolt (2) with the torque spanner to 25 Nm.
8.
Re-insert the bolt (1) and tighten it with a torque of 15 Nm.
9.
Clean any oil residues from the oil drain plug.
10. Check the oil drain plug for tightness after a maximum of
24 hours.
11. Keep a precise record of the amounts of oil removed so that you
never draw more than the maximum permitted quantity from the
system.
ICO 72,5...245
USER MANUAL
When to interrupt the running operation
29/47