4
Pub. No. 8000CLB FEBRUARY 2004
PROTECDOR® CL Model 8000CL
SIDEFRAME INSTALLATION INSTRUCTIONS
3.
Using a water level or string level, determine if the door
opening is level,
Figure 1.
If the opening is not level,
mark the wall where the level point is indicated. The
measurement between the level mark the floor is the
amount of shimming that needs to be done under the
sideframe assembly that will be located on the “Low Side”
(greatest measurement) of the door opening.
4.
Remove both sideframe covers and the motor shroud.
5.
Position the high side sideframe on the wall using the
offset dimension from
Step 1
and using a 6’ level, make
sure that the sideframe assembly is square and plumb in
two directions. Use shims as required to square up the
sideframe assembly to the chalk line.
NOTE:
If no shimming is required, mount the motor drive
side sideframe assembly first.
6.
Using the predrilled holes in the sideframe assembly as a
guide, drill the anchor holes for the wall bolts,
Figure 4.
If the anchor hole goes completely through the wall, use
thru-bolts and backing plates to secure the sideframe
assembly to the wall. Use all available anchor holes to
secure the sideframe assemblies. It is especially important
to fully secure the top hole of each sideframe assembly
with a thru-bolt. Install the fasteners finger tight.
7.
Position the low side sideframe on the wall using the
offset dimension from
Step 1.
Insert the required number
of shims underneath the sideframe base plate to level the
sideframe,
Figure 1.
Using a 6’ level, make sure that the
sideframe assembly is square and plumb in two
directions. Repeat
Step 6
for the low sideframe.
FIGURE 3
This clearance to show
mounting bolts above
track only
No bolts may
interfere with track
Internal Sensing
System track
1/2” Max
Upper right hand
sideframe
Lower right
hand sideframe
FIGURE 5
FIGURE 4
Header Seal Assembly
Washers
Internal Sensing
System Cable
Thru-Beam
Photoeye Cable
3/8” Bolts
IMPORTANT:
Thru-bolt or anchor head
MUST NOT stick out
more than 1/2”
Sideframe
Nut
Thru-bolt
Washer
Wedge type
Sideframe
Backing plate
Backing plate
Nut
Thru-bolt
Washer
