Pub. No. 8000CLB FEBRUARY 2004
27
PROTECDOR® CL Model 8000CL
OPTIONAL INVERTER & THRU-WALL BRAKE RELEASE
Motor Phase Rotation Verification
1.
Press the OPEN/RESET button to reset the door. The
door should fully open and then automatically close after
the reclose timer has expired, unless the door is setup
with the full toggle mode option. The open/reset button will
then need to be pressed again to close the door.
2.
If the door starts closing, turn the disconnect switch off
and lock and tag out the power supply. Have a qualified
electrician reverse any two of the three motor leads,
terminals U, V or W in the control box,
Figure 41.
Reconnect the electrical power and retest the door.
3.
The Inverter parameters are set to open the door at 50
inches/second and close at 20 inches/second.
4.
Adjustments should only be made by a
RITE-HITE
DOORS, INC. training service technician. If the parameters
are altered without consent,
RITE-HITE
DOORS, INC. will
not be liable for problems or damage that may occur.
NOTE:
Reversing the incoming power phases will have no
effect on direction of travel.
THRU-WALL BRAKE RELEASE INSTALL
1.
Remove the lower bolt from the drive side shroud and re-
install it with the conduit clamp.
2.
Insert the two rope guide plugs into the shorter end of the
two ‘L’ shaped conduit pieces.
3.
Using the conduit as a guide, mark the location on the
wall. Check the other side of the wall for clearance, if
clear, drill a 1” Ø hole through the wall, if not move the
conduit left or right.
4.
Install one piece of conduit onto the clamp using the
provided hardware, and attach the splice connector to the
longer end of it.
5.
Insert the other piece of conduit through the wall into the other
end of the splice connector. Cut conduit to desired length.
6.
Thread the rope through the conduit and tie it into the
existing rope.
Motor Terminals U,V,W
FIGURE 41
Inverter
FIGURE 40
FIGURE 39
Center Shroud Bracket
Non-Drive Shroud
Counterweight Guard
Counterweight Channel
5/16” x 3/4” Bolt
The first time that the door system is operated, it may
move in the wrong direction if the motor power phase
rotation is incorrect. Be prepared to turn the Disconnect
Switch if the door begins closing instead of opening.
CAUTION !!!
!
