TURN-TITE SEAL ADJUSTMENT
The PROTECDOR CLEAN is equipped with an adjustable
TURN-TITE seal that runs across the entire door opening. Cycle
the door approximately 10 times to seat the door fabric.
Continue to cycle the door while standing on the back side of
the door opening. Look upwards and observe the gap between
the door opening and the roller tube assembly. No light should
be visible in the gap when the door is fully closed. If light is
visible, inspect the TURN-TITE seal from above. Adjust the seal
so that the sealing edge is aligned about halfway down the
angled face of the header seal and the TURN-TITE seal flexes
into the gap,
Figure 30.
Make sure to secure the hook and loop
fastener along the entire length of the roller tube.
Vertical Side Seals are seals located in the top corners of the
door when it is closed,
Figure 30.
These seals fill the gap
between the curtain fabric and the sideframe assembly just
below the roll tube. If a gap is visible along either side edge,
remove and re-install the seal.
CURTAIN RETENTION CLIPS
1. Retention clips have been installed on the Protecdor
curtain assembly for pressure resistance,
Figure 31.
2. They are located above and below the vision panel at the
edge of the curtain.
3.
There are four per door on doors under 11’ and six on any
doors over 11’ tall.
PROTECDOR® CL Model 8000CL
14
Pub. No. 8000CLB FEBRUARY 2004
TURN-TITE SEAL ADJUSTMENT
FIGURE 30
Correct TURN-TITE
and Vertical Side Seal
Move TURN-TITE Seal
Towards Top Of Roller Tube
Move TURN-TITE Seal
Towards Header Wall Seal
Header Wall
Seal
Vertical Side
Seal
Roller Tube
TURN-TITE Seal
When working with electrical or electronic
controls, make sure that the power source has
been locked out and tagged according to OSHA
regulations and approved local electrical codes.
WARNING!!!
!
FIGURE 31
Cutout View of Retention
Clip in sideframe
Top View of Curtain with
Retention Clip in sideframe
Retention Clips
Internal Sensing
System cable
Must be set at 3/4” gap
Tension
Cable
