7.
Did you check for proper frame alignment when installing
floor anchor bolts and shim as required ?
8.
Did you install a wall mounting bolt in the top hole of both
sideframes and tighten all mounting bolts ?
9.
Did you tighten the pillow block bearing set screws on the
non-drive side to 66 to 80 in.-lb. ?
10.
Did you check drive belt alignment to within 1/32" ?
11.
Are loose wires secured away from moving parts?
12.
Did you check for proper line voltage ?
13.
All wires connected for the internal sensing system and/or
thru-beam photoeyes ?
14.
Sideframe covers adjusted to 3/4” gap clearance ?
TIPS FOR BREAKAWAY REASSEMBLY
The Protecdor Clean is equipped with a breakaway “Internal
Sensing System”. The system is a quick and easy re-assembly
of the curtain after a breakaway occurs. When a breakaway
condition is acknowledged the door will stop, the OPEN button
will flash, and operation will convert to JOG mode.
The “Internal Sensing System” is a thru-wire closed loop circuit
which monitors continuity through the breakaway system. When
continuity is disrupted by the separation of one or both of the
breakaway magnets, a breakaway condition is acknowledged.
To return to normal operation, if the magnets are separated, re-
attach and press the open button.
If the door is in jog mode (OPEN button flashing):
Problem:
The door is broken away and one or more of the
retention clips are outside the front cover.
Solution:
Open the sideframe front covers. Jog the door to the
top and back down to a convenient height for re-
assembly of the magnets. Close front covers.
Problem:
The curtain bunches up enough to stall the motor.
Solution:
Turn power off. Release the manual brake handle in
short intervals until the curtain reaches floor or the
wrinkles are cleared. Turn the power back on and jog
the door to the top. Open the front covers and jog the
door down to reassemble the magnets.
SHROUD INSTALLATION
1.
Run door to the full open position and disconnect the
power and lock/out tag/out and barricade traffic.
2.
Position center shroud and fasten with 1/4” hardware.
3.
Position drive shroud and fasten with 1/4” hardware.
4.
Position non-drive shroud and fasten with 1/4” hardware,
and self tap screw.
5.
Return power to door and verify operation, remove
barricades and return door back to service.
MISC PHOTOS
1.
See the two figures above for gaining access to the
sideframe.
2.
The sideframe is opened by stepping on the Quick
Release system lever located on the outside edge of
either sideframe and swinging the door open.
3.
In the event of the curtain coming out of the sideframe,
the front cover will need to be opened to place the curtain
back in the sideframe.
PROTECDOR®
POWER DOOR Model 8000
Pub. No. 8000CLB FEBRUARY 2004
17
OPERATING INSTRUCTIONS
FIGURE 36
Center Shroud
Non-Drive
Sideframe
Drive Shroud
Drive Sideframe
Non-Drive
Shroud
1/4” Bolt w/Washer
DRIVE SYSTEM
Junction Box
