Right Weigh 201-219-11, Installation & Operation Manual

Page: 8 / 32

8
The next section covers the operation modes that are built into the 201 series
spring sensor only gauges. The load scale can only be setup in one operating
mode at a time. If the mode is changed, the calibration data will be reset to
factory defaults, requiring re-calibration.
• Front _ Back _ Mode (F_b_): This mode monitors two separate axle groups
by separating the air and spring sensors. Each gauge has its own mode:
201-219-11 = F1b1
201-219-12 = F1b2
201-219-21 = F2b1
201-219-22 = F2b2
See following page for a more detailed description.
• Spring Average Air Independent (SA-Ai): This mode is only available for the
201-219-12 gauge. In this mode, each sensor is monitored independently for
measuring three separates axles or axle groups.
Press the UP arrow
button to cycle through
the configuration
modes. To confirm your
selection, turn the scale
off by pressing the
ON/OFF button.
With the scale OFF, hold
both the UP and DOWN
arrow buttons, and press
the ON/OFF button.
Release all 3 buttons. The
scale will display the
current mode.
PRESS
HOLDING
PRESS
CHANGING SCALE MODES (201-219-12 ONLY)
SCALE OPERATING MODES