Phoenix HT User Manual
© 2007–2012 Rigaku Automation, Inc.
33
401718 Rev A
5.4.2
Installing the Replacement Nano Valve Harness
Replacing the nano valve harness includes installing the new harness and updating the software
calibration file.
1. To install the new nano valve harness:
1
Connect the new pneumatic tubing to nano dispenser controller.
2
Insert the new black wiring connector into the nano dispenser controller.
3
Reinstall the P-clamp at the back of the Phoenix system and position the harness in it.
4
Thread the harness between the two cable guide pins on the nano head.
5
Reinstall the second P-clamp onto the front of the nano dispenser head and position the
harness in it with the appropriate amount of slack to allow movement horizontally to the
far left and far right of the Phoenix instrument and vertically down to the bottom of the
wash station.
6
Uncap the nano-tip and slide the nano-tip assembly into the nano head sleeve.
7
Gently insert the white nanotrigger wire clip onto the nano-tip assembly.
Position the harness between the two cable
guide pins on the nano dispenser head
Front view of Phoenix nano dispenser head
Rear view of the Phoenix nano dispenser head
