RIEXINGER BSM 630, Operating Manual

Page: 32 / 70

30 6. Setup and activation
Attention!
Machine can not be connected to:
l
electricity producers, emergency generator, generators
l
voltage transformer
l
static frequency converters
l
mains voltage with a different sinusoidal form
The machine is intended for operation on a power supply with a system impedance smaller than
0.39 ohms at the house connection point. The user must ensure that the machine is operated on
a network which satisfies the above requirements. If necessary, the system impedance can be
requested from the local energy supply company.
1) Ensure that the cables that connect the BSM 630 are equipped with an appropriately dimen-
sioned circuit breaker.
2) Ensure that the phase sequence of the outer cable turns clockwise in the receptacle.
3) Connect the BSM 630 to the power supply by connecting the machine's plug to a receptacle.
We assume no liability for damages resulting from failure to comply with the above
points.
6.6 Initial operation
Do not operate the machine if the power cable, motor cable or the electrical box are visibly dam-
aged!
Attention!
Warning against damage to machine's electrical equipment caused by con-
densation!
Wait several hours before turning on the main switch of the machine if there has
been a sudden change in ambient temperature.
1) Set the machine up (see Chap. 6.4 on p. 27).
2) Remove the transport anchors at the saw bow respectively mount it (see Chap. 6.4 on p. 27)
Danger!
Crushing Danger when removig transportation lock of saw bow!
When removing the transport lock the saw bow can tip backwards.
3) Set the saw bow to 0 degrees (see Chap. 7.4 on p. 34).
4) Connect electrical power supply (see Chap. 6.5 on p. 29).
5) Grease all blank machine guides and lubricate the joints of the saw frame (see Chapter 1.1
on p.1).
BSM 630