T
echnical
B
ulletin
PAGE: 2/5
Reissued: 26-Apr-11
Model:
Al-P1
Date:
13-Mar-08
No
.: RG179008k
Version
Modified Points or Symptom Corrected
number of pages in the current copy. Instead the device will return the total
number of pages for all copies.
1.18 IMPORTANT:
When you update to this version of Printer(ver. 01.18, Program No. G1795746M), be
sure to install the following firmware version (or newer) together as a set, otherwise
the machine will not function correctly.
Upgrade the firmware listed in the table below together as a set, according to the
options that are already installed on the customer's machine.
Firmware: Version:
Program
No.:
Note:
Web Support
1.14
G1795743D
forG179
Network Support
7.34
G1795742J
forG179
Symptom corrected:
1. If IPDS fonts are reset (Menu button > Maintenance > HD Management > Reset
IPDS Fonts), users might not be able to logout from the operation panel.
2. An IPDS Form can be created with unsupported dimensions using Web Image
Monitor (Configuration > IPDS Form List > Media Size = Custom Size > Cross
Feed Dimension/Feed Dimension). Once created it can be selected using the
IPDS Form Allocation setting.
Note:
Supported dimensions for this model are:
Cross Feed Dimension: 182.0 - 297.0 mm
Feed Dimension: 210.0 - 432.0 mm
Note: To fix this problem, Printer firmware (version 1.18 or later), System
firmware (version 1.18 or later) need to be applied to the device.
3. Suspending a job (Suspend/Resume button) and then opening a tray might
result in the printer hanging. The job cannot be resumed and the printer must be
rebooted.
Other changes:
The setting "Menu > Host Interface > Network > Permit SSL/TLS Comm." has been
added.
Note: For this change to take effect, Network Support firmware version 7.34 or later
and Web Support firmware version 1.14 or later both need to be applied to the
printer.
1.17
Symptom corrected:
1. Jobs not containing any PJL commands are held by the device and not printed
until another job is submitted or a button is pressed on the device. This occurred
if the device entered in energy saver mode immediately after printing a
diagnostics page (List/Test Print, etc.).
2. If the Auto Continue setting is "Immediate" and the source tray runs out of paper,
the device will stall. This only occurred if the paper ran out after several small
jobs (30 or 40) were submitted back to back.
