Ricoh SH-P1 M020, Field Service Manual

Page: 112 / 312

13. Insert the VM card into Slot 2 (Lower).
14. Turn on the main power switch.
15. Print the SMC data (”ALL”) using SP5-990-001 ( p.138, and make sure that it matches the
SMC data you printed out in Step 1 above (except for the value of the total counter).
• The value of the total counter is reset to “0” when the NVRAMs are replaced.
• Do all of the following if SP5-824-001 ( p.231) and SP5-825-001 ( p.232) cannot be
performed for some reason:
• 1. Replace the NVRAMs and Security SD card together as a set with new ones.
• 2. Manually enter all data on the SMC report (factory settings).
• 3. Install the new Security SD card functions (Data overwrite and HDD encryption). See RTB
#RGene039 for the procedure.
EEPROM
1. Make sure that you have the SMC report (factory settings). This report comes with the machine.
2. Output the SMC data ( SP5-990-001) if possible.
3. Turn the main switch off.
4. Install an SD card into SD card slot 2 (Lower). Then turn the main power on.
5. Copy the EEPROM data to an SD card ( SP5-824-001) if possible.
6. Turn off the main switch. Then unplug the power cord.
7. Replace the EEPROM on the engine board and reassemble the machine.
8. Plug in the power cord. Then turn the main switch on.
9. Select a paper-size type ( SP5-131-001).
10. Specify the serial number and destination code of the machine.
• Contact your supervisor for details on how to enter the serial number and destination code.
• SC 999 or "Fusing Unit Setting Error" will be shown until the serial number and destination
code are correctly programmed.
11. Turn the main switch off and on.
12. Copy the data from the SD card to the EEPROM ( SP5-825-001) if you have successfully
copied them to the SD card.
13. Turn the main switch off. Then remove the SD card from SD card slot 2 (Lower).
14. Turn the main switch on.
4. Replacement and Adjustment
110
4