Ricoh PRO TF6215, Operating Instructions Manual

Page: 61 / 116

If the dirt will not come off, contact your service representative.
Ink or dust adhered to the irradiation surface can cause an increase in temperature that may eventually
break the glass.
1
M0DTIC0026
1. Irradiation surface is dirty
• The head gap can be set up to 2 mm, but a head gap greater than the recommended 1 mm may
lead to a reduction in image quality.
Changing Print-start Position
You can change the print-start position in the X and Y directions on the [Operation] screen.
1. Click the [Task Print] tab.
2. Select a task.
3. Enter numerical values in [X].
The print-start position of the X-coordinate is set.
4. Enter numerical values in [Y].
The print-start position of the Y-coordinate is set.
Setting Media
59