Ricoh MP 6503, User Manual

Page: 208 / 228

When Other Messages Appear
Message Cause Solution
"Firmware update will start.
Press [OK]. It will start
automatically after 30
seconds have elapsed." Automatic firmware update
is enabled and it is the time
for an automatic update. • If you want to start the firmware
update, press [OK], or configure
the setting so that the automatic
firmware update starts
automatically in 30 seconds.
• If you do not want to start the
firmware update, press [Cancel]
before 30 seconds elapse.
• Do not turn off the power switch
during the firmware update.
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
(A "wireless LAN board" is
referred to as a "wireless
card".) • The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
The settings are not updated
although the unit is detected.
Turn off the power, and then check the
wireless LAN board is inserted
correctly. After this, turn on the power
again. If the message appears again,
contact your service representative.
"Failed to read the PDF file." There is a possibility that the
PDF version is not supported
by the browser’s PDF viewer
or an unsupported
encryption level is specified.
With this machine’s browser PDF files
other than those whose versions and
encryption levels are specified below
cannot be viewed.
• PDF version: 1.3-1.7
• PDF encryption level: 128Bit AES
or 256Bit AES
"Clean the scanning glass.
(Located next to the
exposure glass.)" • The scanning glass or
guide plate of the ADF
is dirty.
Clean the scanning glass or guide
plate. See "Maintaining Your
Machine", Maintenance and
Specifications.
10. Troubleshooting
206