Error
Description
Action
200.27
Printhead Driver: Mirror motor fell out of lock
condition after the media at the input
sensor–more time elapsed since the
printhead than the expected stable lock time,
but less than the printhead jitter-stable
specification.
Check the printhead ( p.263
"Printhead Service Check").
Mirror motor fell out of lock condition after
media at the input sensor–more time elapsed
since the printhead than expected stable
lock time, but less than the printhead jitter-
stable specification.
200.28
First writing line of a page at the developer
nip, but laser servo cleanup is not complete.
Likely pre staged media or a fast paper feed.
Verify that the media is approved. Inspect
the wear strips in the tray, and replace if
they are worn.
200.29
Printhead drive control out of range due to
an external event beyond what the control is
designed to handle. Probable causes: ESD
or noise on hsync signal.
Check the cable routing for the printhead
( p.263 "Printhead Service Check").
200.30
Narrow media sensor covered during warm-
up.
Check that the narrow media flag rotates
freely and securely. If it is dislodged or
broken, then replace the rear exit guide
( p.103 "Rear Exit Guide Assembly
with Sensor and Reversing Solenoid
Removal").
200.32
Media more than 14 inches too long over
the manual feeder sensor. Possible causes
include multi-sheet feed or pre-staged media
in the tray.
Verify that the media is approved. Inspect
the wear strips in the tray, and replace if
they are worn.
6. Troubleshooting
212
6
Summary of Contents for LI-MF1 M126
