Ricoh LD013, Service Manual

Page: 79 / 513

Rep
lac
emen
t
Ad
ju
s
tm
e
n
t
SCANNER SECTION
SM 3-11 B039/B040/B043
3.4.2 LENS BLOCK
1. Exposure glass (
☛
3.4.1)
2. Lens cover [A] (
!
x 5)
3. Disconnect the flat cable [B].
4. Lens block [C] (
!
x 4).
NOTE: Do not loosen the paint-
locked screws holding the
lens unit in place.
After installing the new lens block, do
the copy adjustments (
☛
3.13).
3.4.3 EXPOSURE LAMP, LAMP STABILIZER BOARD
1. Exposure glass (
☛
3.4.1)
2. Operation panel (
☛
3.3.5)
3. Slide the 1st scanner to a position
where the front end of the lamp is
clear of the metal lids.
4. Place your right hand under the
lamp stabilizer board [D] on the
underside of the 1st scanner, to
support the board when it drops.
Press hook [E] with your left thumb
to release the board.
5. Disconnect the lamp connector [F].
If you wish, you can now remove
the lamp stabilizer board (by
disconnecting the flat cable).
6. Remove the front reflector [G].
7. Press on the plastic latch [H] and at the same time push the plastic end of the
lamp toward the rear, so that the lamp snaps free. Remove the lamp together
with the lamp cable.
B039R003.WMF
B039R006.WMF
[B]
[C]
[A]
[H]
[G]
[D]
[E]
[F]