Ricoh LD013, Service Manual

Page: 118 / 513

COPY ADJUSTMENTS: PRINTING/SCANNING
B039/B040/B043 3-50 SM
3.13 COPY ADJUSTMENTS: PRINTING/SCANNING
NOTE: 1) You need to perform these adjustment after executing a Memory All
Clear, and after replacing or adjusting any of the following parts.
•
First or second scanner
•
Lens Block
•
Scanner Motor
•
Polygonal Mirror Motor
•
Paper Tray
•
Paper Side Fence
2) For detailed explanations about how to access and use the SP modes,
see Section 5.
3.13.1 PRINTING
NOTE: 1) Make sure the paper is installed correctly in each paper tray before you
start these adjustments.
2) Use the Trimming Area Pattern (SP5-902, No.10) to print the test
pattern for the printing adjustments below.
3) Set SP 5-902 to 0 again after completing these printing adjustments.
Registration - Leading Edge/Side-to-Side
1. Check the leading edge registration for each paper feed station, and adjust
each of these registrations using SP1-001.
2. Check the side-to-side registration for each paper feed station, and adjust
these registrations using SP1-002. (Adjust the trays in order: the 1st tray first,
then the 2nd tray, etc.)
Tray SP mode Specification
Any paper tray SP1-001-1
By-pass feed SP1-001-2
Duplex SP1-001-3
2
±
1.5 mm
1st tray SP1-002-1
2nd tray SP1-002-2
3rd tray
(Optional PFU tray 1)
SP1-002-3
2
±
1.5 mm
4th tray
(Optional PFU tray 2)
SP1-002-4
By-pass feed SP1-002-5
Duplex SP1-002-6
B
A
B039R558.WMF A: Leading Edge Registration
B: Side-to-side Registration