Ricoh LD013, Service Manual

Page: 411 / 513

fax Un
it
b
4
0
4
ERROR CODES
SM 4-7 B404
Code Meaning Suggested Cause/Action
5-22 Mode table overflow after
the second page of a
scanned document
•
Wait for the messages which are currently in
the memory to be sent or delete some files
from memory.
5-23
Print data error when
printing a substitute rx or
confidential rx message
•
Test the SAF memory.
•
Ask the other end to resend the message.
•
Replace the FCU board.
5-24
Memory overflow after the
second page of a scanned
document
•
Try using a lower resolution setting.
•
Wait for the messages which are currently in
the memory to be sent or delete some files
from memory.
5-25 SAF file access error
•
Replace the FCU board.
6-00 G3 ECM - T1 time out
during reception of
facsimile data
6-01 G3 ECM - no V.21 signal
was received
6-02 G3 ECM - EOR was
received
•
Try adjusting the rx cable equalizer.
•
Replace the FCU or NCU.
6-04 G3 ECM - RTC not
detected
•
Check the line connection.
•
Check connections from the NCU to the FCU.
•
Check for a bad line or defective remote
terminal.
•
Replace the FCU or NCU.
6-05
G3 ECM - facsimile data
frame not received within
18 s of CFR, but there was
no line fail
•
Check the line connection.
•
Check connections from the NCU to the FCU.
•
Check for a bad line or defective remote
terminal.
•
Replace the FCU or NCU.
•
Try adjusting the rx cable equalizer
Cross reference
•
Rx cable equalizer - G3 Switch 07 (PSTN)
6-06 G3 ECM - coding/decoding
error
•
Defective FCU.
•
The other terminal may be defective.
6-08 G3 ECM - PIP/PIN
received in reply to
PPS.NULL
•
The other end pressed Stop during
communication.
•
The other terminal may be defective.
6-09 G3 ECM - ERR received
•
Check for a noisy line.
•
Adjust the tx levels of the communicating
machines.
•
See code 6-05.
6-10 G3 ECM - error frames still
received at the other end
after all communication
attempts at 2400 bps
•
Check for line noise.
•
Adjust the tx level (use NCU parameter 01 or
the dedicated tx parameter for that address).
•
Check the line connection.
•
Defective remote terminal.