5.6 DEVELOPMENT ROLLER REPLACEMENT
1. Remove the devel-
oper. (See "DE-
VELOPER
REMOVAL".)
2. Remove the top
left cover, middle
left cover, and left
horizontal cover.
3. Remove the top right cover, middle right cover, and right horizontal cover.
4. Remove the exposure glass and the exposure lamp.
5. Remove the upper toner supply bracket [A] (3 screws).
6. Disconnect the toner sensor connector and remove the doctor blade.
(Refer to "DOCTOR GAP ADJUSTMENT".)
7. Remove the devel-
opment motor.
(See "TONER SUP-
PLY CLUTCH LU-
BRICATION".)
8. Disconnect the bias terminal [B] and remove the development drive gear
[C], two development roller adjustment plates [D], two bearings [E], and
the auger gear [F] (1 screw, 1 C ring, 2 E rings, 1 bushing).
[A]
[F]
[E]
[C]
[D]
[B]
6 January 1990
5-23
Summary of Contents for FW 810
