Ricoh FT7950, Operating Instructions Manual

Page: 86 / 140

72
WHAT TO DO IF SOMETHING GOES WRONG
Display
Problem
The panel display
is off.
Cause
The display brightness
knob is set to the darkest
position.
The machine is in Energy
Saver mode.
The operation switch is
turned off.
The main switch is turned
off.
Action
Adjust the brightness knob to a position that is
enough to show the display. See
⇒
P.7 “OPERA-
TION PANEL.”
Press the
{
Clear Modes/Energy Saver
}
key to can-
cel Energy Saver mode.
Press the
{
Clear Modes/Energy Saver
}
key to re-
set the display off state.
Turn on the main switch.
Message
Stapling
canceled.
The following
paper sizes cannot
be stapled.
The following
paper sizes cannot
be duplexed.
Copy capacity is
over the limit
→
xxx.
Problem/Cause
The paper size was
changed during stapling.
You selected a type of copy
paper that did not allow 2-
sided copy.
The upper limit number of
copies was exceeded.
Action
You can staple only forms of the same size. Select
forms of the same size.
The types of paper you can staple are A3
L
, B4
L
,
A4
KL
, B5
KL
, 11"
×
17"(DLT)
L
, 8-
1/2
"
×
14"(LG)
L
, and 8-
1/2
"
×
11"(LT)
KL
. Select one
of these paper sizes.
The types of paper you can copy on its sides are
A3
L
, B4
L
, A4
KL
, B5
KL
, A5
K
, 11"
×
17"(DLT)
L
, 8- 1/2 "
×
14"(LG)
L
, and 8- 1/2 "
×
11"(LT)
KL
.
You can set the upper limit number of copies you
can copy at a time. See
⇒
P.101 “Maximum copy
input number.”