Ricoh BE-C1 D046, Field Service Manual, Page: 647 / 734

Selects the brand name and the production name for Windows Plug & Play. This information
is stored in the NVRAM. If the NVRAM is defective, these names should be registered again.
After selecting, press the "Original Type” key and "#” key at the same time. When the
setting is completed, the beeper sounds five times.
5913 Switchover Permission Time: Print Application Timer GW
Sets the length of time to elapse before allowing another application to take control of the
display when the application currently controlling the display is not operating because a
key has not been pressed.
[3 to 30/1 s]
5967
Copy Server: Set Function GW
Enables and disables the document server. This is a security measure that prevents image
data from being left in the temporary area of the HDD. After changing this setting, you must
switch the main switch off and on to enable the new setting.
0: ON 1: OFF
5974 Cherry Server Japan Only GW
5985
Device Setting
The NIC and USB support features are built into the GW controller. Use this SP to enable
and disable these features. In order to use the NIC and USB functions built into the controller
board, these SP codes must be set to "1".
1 On Board NIC
[0 to 2 / 0 / 1 /step]
0: Disable, 1: Enable, 2: Function limitation
When the "Function limitation" is set, "On board NIC" is limited for use with only NRS or
LDAP/NT authentication.
Note:
• Other network applications than @Remote or LDAP/NT authentication are not
available when this SP is set to "2".
• Even if you can change the initial settings of those network applications, the settings
will not work
2 On Board USB
System Service Mode
199
8