Ricoh BE-C1 D046, Field Service Manual

Page: 573 / 734

2801 Developer Initial Setting
Execute this SP only after replacing the developer. Executing this SP raises the chargeability of
the developer in the development unit.
You must also enter the lot numbers of the toner that has just been installed.
Note: The lot number is embossed on the top edge of each developer pack.
1 Initialize Developer: Execute Press [Start] to execute.
2 Lot Number 1
Enter the lot numbers with the 10-key pad.
3 Lot Number 2
2803 Charge Corona Wire Cleaning
Press [Start] to clean the charge corona wire. Executing this SP also ensures that the cleaning
pad is set at the home position.
Cleaning requires about 60 seconds.
2804 Corona Wire Cleaning Interval
This SP selects the interval between corona wire cleanings.
[0 to 6/3/1]
0: None (no cleaning)
1: After main power SW on
2: After 300 m prints (job end)
3: After 600 m prints (job end)
4: After 900 m prints (job end)
5: After 1200 m prints (job end)
6: After 1000 m prints (job end)
2902
Test Pattern
Select the test pattern number, touch [Copy Screen], then push [Start].
Operates the test pattern printing. Enter the number for the desired test pattern, switch the
display to the "Copy Window" then press the [Start] button. Once you leave the SP mode,
the pattern selection is disabled and the test pattern cannot be printed.
System Service Mode
125
8