Ricoh BE-C1 D046, Field Service Manual, Page: 531 / 734

10
1st Roll/2nd Roll
D046: [-20 to +20/-5/1 mm]
D049: [-20 to +20/0/1 mm]
11
3rd Roll/4th Roll
D046: [-20 to +20/-5/1 mm]
D049: [-20 to +20/0/1 mm]
This SP adjusts the amount paper buckle created when the paper hits the registration roller.
When the leading edge of paper longer than 460 mm from Tray 1, or paper longer than 690
mm from Tray 2, stops temporarily at the registration roller, even if the paper is stretched tight
or there is too much slack, this can be corrected. After paper feed and registration roller rotation
resume the paper is fed the prescribed distance to create buckle, the paper feed motor stops,
then the paper is cut.
1103 Fusing Idling DFU
Selects the fusing idling time.
[0 to 5/0/1 min.]
If the fusing temperature is below 100°C when the machine is turned on, idling starts as soon
as the hot roller reaches the target temperature. However, if the fusing temperature is below
15°C the hot roller will idle for at least 1 minute, even with this SP set to "0" (OFF: No idling).
1105 Fusing Temp. Adjustment
1 Copy Ready Temperature
This setting is used to determine the copy ready temperature. Copying can start at this
temperature before the target control temperature set with SP1931-3.
Note: This SP code applies to Mode 3 only.
[0 to 50/40/1°C]
Example:
195 - 40 = 155°C
where "195" is the target control temperature set with SP1931-3 and "40" is the default setting
of SP1105-1.
2 Edge Temperature DFU
When the temperature set for the ends of the fusing roller is different from the temperature at
the center, the setting for this SP is subtracted from the value of the target center temperature.
System Service Mode
83
8