Ricoh AficioSP C410DN, Hardware Manual

Page: 98 / 204

Paper and Other Media
86
5
Envelopes
Note
❒
If the printing result is badly wet or smudged, change the setting on the printer's
control panel as the following:
• Press the
{
Menu
}
key, select
[ Maintenance ]
,
[ General Settings ]
, and then select
[ Envelope ] . Select one from [ Envelope 1 ] , [ Envelope 2 ] , [ Envelope 3 ] , or [ Enve-
lope 4 ]
.
The greater number corresponds to the thicker setting.
The one of these items is normally detected automatically according to the pa-
per type you set. It is not necessary to change this setting when the printing
result has no problem.
Printer setup Make the following settings using the control panel:
• Press the
{
Menu
}
key, select
[ Paper Input ]
, and then select
[ Enve-
lope ] for the selected tray's paper type.
Printer driver setup Select [ Envelope ] in the [ Paper type: ] list.
Enabled paper feeding tray Any input tray can be used.
Make sure paper is not stacked higher than the upper limit mark
(
T
) inside the tray. Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Duplex printing Not possible
Additional cautions • If printed envelopes come out badly creased, load the enve-
lopes in the opposite direction. Also, configure the printer
driver to rotate the print object 180 degrees.
• Load envelopes print side down on the bypass tray.
• Load envelopes print side up in the input tray or optional paper
feed unit.
• Check there is no air in the envelopes before loading.
• For better print quality, we recommend the right, left, top, and
bottom print margins to be at least 20 mm (0.8 ”) each.
• Load only one size and type of envelope at a time.
• Before loading envelopes, flatten their leading edges (the edge
going into the printer) by running a pencil or ruler across
them.
• Some kinds of envelope might cause misfeeds, wrinkles or
print poorly.
• Print quality on envelopes may be uneven if parts of an enve-
lope have differing thicknesses. Print one or two envelopes to
check print quality.
• In a hot and humid environment, the envelope might be out-
put creased or improper printing quality.