Ricoh Aficio AP-4510 G065, Service Manual, Page: 197 / 278

SOFTWARE DOWNLOAD
SM 5-39 G065
Serv
ic
e
Ta
b
le
s
5.4 SOFTWARE DOWNLOAD
5.4.1 DOWNLOADING THE SOFTWARE
Before downloading the software, please note:
•
If you are downloading the Engine software for the BICU, 1 card is required.
•
If you are downloading the Controller software, 2 cards are required.
•
Follow the basic procedure described below to install the software for either the
Engine or the Controller.
1. Turn off the main power switch.
2. Remove the IC card [A] cover.
3. Insert the IC card [B] containing the software
to download into the card slot of the
controller.
4. Turn on the main power.
Onboard Sys. 1/2
5. Press #(Enter). An asterisk appears in the
LCD.
6. Press
"
to display “Update Data”, then press
#(Enter) to start writing the data from the card to the printer.
7. Monitor the downloading status on the operation panel. While downloading is in
progress, the LCD will display some dashes, slowly replaced by asterisks
(***-----) moving left to right.
!
CAUTION
Never switch off the power while downloading. Switching off the power
while the new software is being downloading will damage the boot files in
the controller.
After confirming that downloading is completed, the LCD displays:
Updated
Power Off/On
8. Turn off the main power and remove the IC card.
9. If you are installing the software for the Engine (BICU), go to the next step.
If you are installing the software for the Controller, you must repeat the
procedure for the second card.
10. After all the software has been downloaded, turn the main power on and
confirm that the new software loads and that the machine starts normally.
G065S900.WMF
[A]
[B]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA