Ricoh Aficio AP-4510 G065, Service Manual, Page: 148 / 278

SERVICE CALL CONDITIONS
G065 4-10 SM
SC Level Symptom Possible Cause
GAVD FCI block I
2
C bus error 691 A
An error is detected in the FCI
communication I
2
C control register of
the GABIC2.
•
I2C bus on BICU defective
CDIC GAVD block I
2
C bus error 692 A
An error is detected in the CDIC
communication I
2
C control register of
the GABIC2.
•
I2C bus on BICU defective
Finisher jogger motor error 722 B
The finisher jogger H.P. sensor does
not return to the home position, or
move out of the home position, within
the specified time.
•
Jogger H.P. sensor defective
•
Jogger motor defective
Finisher staple hammer motor error 724 B
Stapling not complete within 600 ms
after the staple hammer motor turns
on.
•
Staple jam
•
Stapler overload caused by trying
to staple too many sheets
•
Staple hammer motor defective
Finisher stack feed-out motor error 725 B
The stack feed-out belt H.P. sensor
does not activate within the specified
time after the stack feed-out motor
turns on.
•
Stack feed-out H.P. sensor
defective
•
Stack feed-out motor overload
•
Stack feed-out motor defective
Finisher shift tray 1 lift motor error 726 B
•
Tray shift does not finish within the
specified time after the shift motor
turns on
•
Stack height sensor does not
activate within the specified time
after the shift tray lift motor turns
on.
•
Shift motor defective or
overloaded
•
Shift tray lift motor defective or
overloaded
Finisher stapler rotation motor error 727 B
The H.P. sensor does not switch on
or off within the specified time, i.e.
stapler rotation does not finish within
the specified time after the staple
rotation motor turns on, or the stapler
does not return to its H.P. within the
specified time after stapling finishes.
•
Stapler rotation motor defective or
overloaded
•
Stapler rotation motor connection
loose or connector defective
Finisher punch motor error 729 B
After the punch motor turns on, the
punch H.P. sensor does not activate
within the specified time.
•
Punch motor defective or
overloaded
•
Punch H.P. sensor defective
•
Punch motor connection loose or
connector defective
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA