SpaceLogger
®
.S10
User Manual
©2012-13 Richard Paul Russell Limited, New Harbour Building, Bath Road, Lymington SO41 3SE United Kingdom
Tel +44 (0) 1590 679755 Fax +44 (0) 1590 688577 e-mail [email protected] web www.r-p-r.co.uk
- 22 -
017SL167/3 04/09/13
5.22
SETUP.TXT file
The SETUP.TXT file is created as follows:
1.
Insert SD card into card reader attached to USB port of PC (or use integrated card reader if
the PC has one).
2.
Open notepad or similar text editor and type the required command line or lines. Refer to
sections above for explanation of commands.
3.
Commands may be typed in upper or lower case but they will be converted to upper case
before execution.
4.
The SETUP.TXT file may contain a list of commands. For example, to set up all available
parameters, the file SETUP.TXT should contain the following lines:
WAIT
TIME=hh:mm:ss
DATE=DD/MM/YYYY
STX=“cc…”
ETX=“cc…”
SENTENCE2=s
STX2=“cc…”
ETX2=“cc…”
LOGSTX=g
LOGETX=g
LOGSTX2=g
LOGETX2=g
SEPARATOR=p
NEWLINE=l
TIMEOUT=m
RX2=x
BAUD=b
RATE=r
SINGLEFILE=f
FILE=ff.nnn
TIMESTAMP=t
LOG_ALL=a
OUTPUT=o
HANDSHAKE=h
RESPONSE=“cc…”
RAW=w
SWITCH=c
STARTUP=u
RX_INV=i
5.
Comments may be added to the SETUP.TXT file using //. The SpaceLogger will not read
any text following // until the end of the line.
