680 Synergy Plus – Digital Weight Indicator
30
Visit our website
4.4.4.3 Ethernet Menu
Figure 4-11. Communication – Ethernet Menu
Parameter
Description
mac id
Mac ID – Read only;
Settings: 00:00:00:00:00:00
dhcp
DHCP – Dynamic Host Configuration Protocol (static allocation of IP address when OFF);
Settings:
ON
(default), OFF
enabled
Enabled – Enables Ethernet communications;
Settings:
OFF
(default), ON
ip addr
IP Address;
Enter value: 0.0.0.0
subnet
Subnet Mask;
Enter value: 255.255.255.0
gateway
Default Gateway;
Enter value: 0.0.0.0
ethsrvr
Ethernet Server – Allows the 680 to receive external EDP commands;
Sub-parameters:
NAME – Name for Ethernet Server;
Enter characters: Alphanumeric entry up to 8 characters,
TCPS
(default)
PORT – Specifies IP Address port to open to establish communications;
Enter value: 1025–65535,
10001
(default)
INPUT – Sets the input trigger type;
Settings:
CMD
(default), NONE
ECHO – Specifies if characters received by the port are echoed back to the sending unit;
Settings:
OFF
(default), ON
TERMIN – Line Termination: Sets the termination character for data sent from the port;
Settings:
CR/LF
(default), CR
RESPNSE – Specifies if the port transmits replies to serial commands;
Settings:
ON
(default), OFF
ethclnt
Ethernet Client – Allows the 680 to send EDP commands to external devices;
Sub-parameters:
ECHO – Specifies if characters received by the port are echoed back to the sending unit;
Settings:
ON
(default), OFF
EOLDLY – End of Line Delay: Sets the delay period from when a formatted line is terminated to the beginning of the
next formatted serial output (measured in milliseconds);
Enter value: 0–255,
0
(default)
IP ADDR – IP Address;
Enter value: 0.0.0.0
TERMIN – Line Termination: Sets the termination character for data sent from the port;
Settings:
CR/LF
(default), CR
NAME – Name for Ethernet Client;
Enter characters: Alphanumeric entry up to 8 characters,
TCPC1
(default)
PORT – Specifies IP Address port to look for to establish communications;
Enter value: 1025–65535,
10001
(default)
RESPNSE – Specifies if the port transmits replies to serial commands;
Settings:
ON
(default), OFF
INPUT – Sets the input trigger type;
Settings:
CMD
(default), STRIND, STRLFT, REMOTE
DISCTIM – Disconnect Timeout (in seconds);
Enter value: 0–60,
0
(default)
Table 4-10. Communication – Ethernet Menu Parameters
Setup
Comm
ETHrNET
DHCP
enabled
IP ADDR
subnet
gateway
EThSRVR
NAME
PORT
input
ECHO
TERMin
ReSPNSE
EthCLNT
ECHO
EOLDLY
IP ADDR
TERMin
NAME
PORT
ReSPNSE
input
disctim
mac id
