Page 16 / 17
In addition, it is recommended to use quick-release fasteners in the appropriate places so that the device can be
quickly separated from the fixed piping for cleaning and / or maintenance (or storing before winter).
In the event of permanent installation, the plug must be visible and easily accessible at all times.
Do not forget that water and equipment connected to the device add weight to it.
4.8- Start-up
Warning
! The pump should be filled with water after each new connection or in the event of water loss or air
intake. Extended operation without a water refill (unsupervised dry run) will destroy the pump.
- Unscrew the priming screw on the pump casing.
- Using a receptacle, fill the pump body until overflowing occurs.
Do not splash water on the electrical parts.
- Put the priming screw back and screw it sufficiently tight to prevent air intake.
- If the water level drops in the pump body or the water does not discharge properly, it is likely due to air
intake; therefore, switch off the pump and re-examine the suction pipe fittings and proceed again with priming
by filling water in the pump body.
Ensure that there is no water on the electrical parts of the pump.
- Start the pump and check there is no leakage on the pump body, suction line and fittings.
When water runs out evenly, turn the pump off. The pump is ready for use.
- If the water does not flow and the pump does not suck water, make sure there are no leaks in the pump body,
pipes and fittings
V. OPERATION
5.1- Intended use
- The water pump is designed to suck up treated water.
- The pump must be installed in a dry, ventilated location, not exposed to bad weather, excessive heat and cold.
- The maximum suction height must not exceed [See table 1].
- When correctly installed, your pump will operate with maximum efficiency and entirely to your satisfaction.
- The water pump is designed for routine private household uses (in the house or in the garden) such as
gardening, sprinkler systems, increasing water pressure of the non-feed water distribution network, pumping
of tank water and jet washing.
- The system (pump with VFD) are ideal to maintain a constant flow level at multiple usage draw-points
within the distribution line ate the preset pressure level.
- The pump must not be operated for uses not specified in this manual.
It should NOT be used in particular for:
- supplying systems and sprinkling equipment for public gardens, public parks …
- continuous operation (for ex.: water circulation…)
- pumping corrosive liquids, easily flammable, aggressive, explosive or dangerous liquids.
- pumping seawater (salted water), waste water, water containing solids, sand or abrasive particles in
suspension, water containing corrosive substances in general.
- pumping water intended for human consumption or any other food liquid.
- pumping water / liquid having a temperature above 35°C.
NOTE:
- This pump is not designed to be used in swimming pool cleaning or other pool maintenance tasks.
- The pump must not be used in outdoor fountains, garden ponds and similar areas.
- The pump is not intended for artisanal, industrial, professional and / or commercial applications (e.g. in
construction sites, public parks, sports fields...).
- The manufacturer or seller cannot be held responsible for incorrect or non-compliant use of the system.
5.2- Operation
