- Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and
any other conditions that may affect its operation.
- All parts should be installed properly to comply with the conditions of the machine’s safe
operation.
- A protective guard or any other part that is damaged should be properly repaired or replaced by an
authorized service centre unless otherwise indicated in this instructions manual.
- Do not use the tool if the switch does not turn it on and off.
- Have defective switches replaced by an authorized service centre
11. Warning
The use of any accessory or attachment, other than one recommended in this instructions manual
may present a risk of injury (to persons or animals) and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons while working with the shredder.
12. Have your tool repaired by a qualified person
This electric tool complies with the relevant safety rules.
Repairs should only be carried out by qualified persons using original spare parts; otherwise this
may result in considerable danger to the user.
The use of unauthorized parts or failure to follow the maintenance instructions may result in injury
or damage.
13- Warning! This appliance must be earthed
Before inserting the plug into the mains socket, make sure that the socket ratings are correct and
correspond to those indicated on the rating label of the shredder
14- Warning! Use only three-core extension cables with the earth wire connected.
Only use extension cables that are approved for outdoor use and check that they are in good
condition before use.
Protect the cables from any damage by excessive mechanical stress, sharp edges, contact with
moving parts and corrosive liquids, etc.
Warning! Do not use an extension cable that shows any signs of damage. Have a complete new
cable fit - do not undertake yourself any permanent or temporary repairs. Have the cable replaced
by a qualified technician
15- Never move the shredder by pulling the cables.
Always disconnect the machine from the mains supply before transporting it to other places.
Always switch off the shredder before disconnecting any plug and socket connector or extension
cables
16- Never leave the shredder unattended while it is switched on.
Before leaving the shredder, switch off the motor and unplug the connection cable. Proceed in the
same way in the event of a power failure
17-
Caution! This machine contains a rotating chopping knife.
Caution! This knife does not stop immediately after switching off.
Always switch off the shredder, unplug the connection cable and wait until the chopping knife
comes to stop before carrying out any maintenance or cleaning work.
Be careful when cleaning the shredder or performing any maintenance.
DANGER! Watch your
fingers! Wear gloves!
18- It is forbidden to move or modify any of the electrical and mechanical safety devices.
19-
Caution! The hopper must be completely fitted and tightened before use.
20- Neither put your hands in the feed funnel nor in the discharge chute
21- During operation, ensure that no foreign objects (such as stones, glass, metal, earth, plastics)
are fed into the shredder as such foreign bodies could cause blunting of the chopping knife and
seriously damage the motor.
22- If the shredder should start to vibrate abnormally, immediately switch off the motor and check
for the cause. In general, vibration is a warning of trouble.
23- Ensure the chopping knife is secure before shredding any material. Do not operate the shredder
if the chopping knife is not properly mounted.
24- Work with your shredder only in places where it is protected from water and never use it
outdoors in rainy weather.
25- Attention!
