1- Position 1 (Fig.3)
The reversing switch has been set to position 1.
The chopping knife will pull in the material and chop it.
2- Position 0 (Fig.3)
When the chopping knife is jammed so that the motor cannot keep running, first press the red
button of the On/Off switch (3) to stop the motor.
Then completely set the reversing switch to position 0 and press the green button of the On/Off
switch (3).
Keep the green button of the On/Off switch (3) pressed; the chopping knife will rotate into the
reverse direction and release the material to enable you to remove it.
When you release the on/off switch (3) the shredder will stop automatically.
Note: after releasing the jammed material, reposition the reverse switch in position 1.
Caution! Always wait until the shredder completely stops before restarting it.
Large objects or pieces of wood are removed after repeated operation in the reverse direction of the
blade.
4.7- Overload protection (Fig.3)
Overload (e.g. blocking up of the chopping knife) will lead to a standstill of the machine after a few
seconds. To protect the motor from getting damaged, the overload switch will automatically cut off
the mains supply.
Wait at least 1 minute before restarting by first pressing the reset button (2) and then the On/Off
switch (3).
If the chopping knife is blocked turn the reversing switch (4) to position 0 before switching on the
shredder again.
4.8- Disassembling
For certain purposes, e.g. storage after use, etc, you can disassemble the shredder in the reverse
order as described under "Assembly".
V. OPERATION
WARNING:
Ensure that other persons and animals remain away from shredder and work
zone when you are operating the shredder.
5.1- Intended use
- The product is intended for domestic outdoor or under shelter use in private domain.
- The product is intended for shredding organic plants within the limits of its characteristics.
- This machine may not be used to do other things outside of the described scope in this manual.
- Do not use the machine for unsuitable purposes (for ex. for cutting stones…)
- The tool is not intended for professional or industrial use (for ex.: in public parks, etc).
5.2- Operation warnings:
1- Before starting the machine, look into the feeding chamber to make sure that it is empty.
2- Keep your face and body away from the feed intake opening.
3- Do not allow your hands or any other part of your body or your clothing to get inside the feeding
chamber, discharge chute, or near any moving part.
4- Do not overreach. Never stand at a higher level than the base of the machine when feeding
material into it.
5- Always keep the discharge zone clear when operating this machine.
6- If the cutting mechanism strikes any foreign objects, or if the machine should start making any
unusual noise or vibration, shut off the motor and allow the machine to stop. Unplug the connection
cable (to disconnect the electric unit from the mains power supply) and take the following steps:
a) Inspect for damage;
