54
Figure 4-30
Step 5 Click Save button.
Device goes back to Display interface.
Step 6 Click Save button.
4.2.2
PTZ
Note
All the operations here are based on PELCOD protocol. For other protocols, there might be a
little difference.
Cable Connection
Please follow the procedures below to go on cable connection
Connect the dome RS485 port to NVR 485 port.
Connect dome video output cable to NVR video input port.
Connect power adapter to the dome.
4.2.2.1 PTZ Settings
Note
The camera video should be in the current screen. Before setup, please check the following
connections are right:
PTZ and decoder connection is right. Decoder address setup is right.
Decoder A (B) line connects with NVR A (B) line.
Step 1 On the main menu, from setting to Pan/Tilt Control,
Enter PTZ interface. See Figure 4-31.
Step 2 Select a channel.
Step 3 Set parameters.
PTZ type: Please select remote mode if you are connecting to the network PTZ
camera.
Protocol: Select corresponding PTZ protocol(such as PELCOD)
Address: Default address is 1.
Baud rate: Select corresponding baud rate. Default value is 9600.
Data bit: Select corresponding data bits. Default value is 8.
