27
3 Boot up and Shut down
Make sure a monitor has properly connected to the video output port of the device. Otherwise
there is no video output.
Check there is a work-write HDD or not, otherwise device cannot record.
Caution
The rated input voltage matches the device power on-off button. Please make sure the power
wire connection is OK. Then click the power on-off button.
To protect device, please connect device to the power adapter first and then connect the power
cable.
Always use the stable current, if necessary UPS is a best alternative measure.
3.1 Boot up
Turn the device key to
, turn the vehicle key to ACC. The power indicator light becomes on. It
may take a while for the device to boot up. It goes to multiple-window preview mode by default
after booted up.
Note
The system can automatically backup video and resume previous working status after power
failure.
Use ACC to boot up
Turn the vehicle key to the ACC, the power indicator light is on and device is booting up. The
device is in preview mode by default. The record mode is auto. Refer to chapter 4.1.6 Manual
record for detailed information.
Auto record
System enables schedule record function if the boot up is within the specified period. The
corresponding record indicator light becomes on and system runs normally.
3.2 Shut Down
In the default setup, the device will automatically shut down after the ACC power is
disconnected.
The ACC delay value ranges from 0 to 65535 (Unit: minute). System can delay shutting down
for the specified time and then turn off
（
Main menu->Vehicle>Auto maintain
）
.
