HN-1010/1510
Depending on whether HopNet radio is configured as a Remote or Base when first
connected, the heading on the Parameters page will display either “Remote
Parameters” or “Base Parameters.” If the radio has a Modbus adapter, Transparent,
Modbus and DNP3 selections will appear above the Point-Point-Multipoint selection
as shown below.
Modbus mode is selected to prevent Modbus errors from occurring due to inter-
character gaps that are too long. Refer to the section, Modbus Operation for details on
this mode.
Network Number
This parameter is also known as Set Hopping and is the same command as
wn
.(Refer
to “Configuration Commands” section for additional information on commands.) By
using different network numbers or “hopping patterns”, nearby or co-located
networks can avoid interfering with each other’s transmissions.
BaudRate
Also known as Set Data Rate Divisor (command
sd
) this parameter sets the serial bit
rate between the modem and the host.
©
2000- 2004 Cirronet
™
Inc
21
M-2410-0010 Rev A
