HN-1010/1510
Network Commands
Network commands are used to set up a HopNet network and to set radio addressing
and configuration.
Command Description
wb[?|0|1]
Set Transceiver Mode
0 = remote (default)
1 = base station
wd[?|1-3f] (base
only)
Set Default Handle
Used to override automatic handle assignment by the base station
30 = default
wg[?|0|1|2]
Enable Global Network Mode
0 = Link only to hop pattern specified by wn parameter (default)
1 = Link to any hop pattern, regardless of wn parameter
2 = Seamless roaming mode
wn[?|0-3f]
Set Hopping Pattern (Network Number)
0 = default
wp[?|0|1] Set
Transmit
Power
0 = 10mW
1 = 100mW (default)
wr?
Read Receive Signal Strength (remote only)
wu[?|0|1]
Set Point-to-Point Direct Mode
0 = Multipoint mode (default)
1 = Point-to-point direct mode
dx[?|0-FF] (remote
only)
Set Range optimization
0 = default
Set Transceiver Mode
Sets modem operation as either base station or remote. Default is remote.
Set Default Handle
This handle will override the automatic handle assignment by the base station. When
specified for the base, the default handle determines which remote it will address
when transparent protocol mode is in effect. When 3FH is specified for the base,
broadcast mode is entered.
©
2000- 2004 Cirronet
™
Inc
40
M-2410-0010 Rev A
