26
27
26
27
3. If the desired angle is one of the
positive stops, tighten the positive stop
lock lever, and then flip the lock lever
down to lock the sliding fence unit.
Positive stops for compound cutting
are provided at 0°, 22.5° and 45°.
4. If the desired angle is not one of
positive stops, simply lock the
sliding fence unit by flipping the lock
lever down.
5. Unlock the left sliding fence plate by
loosening the knob, and slide the left
sliding fence plate leftward for avoiding
interference, and tighten the knob.
6. Lock the right sliding fence at the
angle 45° forward, loosen the knob,
and slide the right sliding fence plate
rightward to the distal end for avoiding
interference, then tighten the knob.
7. Loosen the bevel lock handle and
position the cutting head at the
desired bevel angle which can be
read from the bevel scale, and then
tighten the bevel lock handle.
8. Place the workpiece against the left
sliding fence plate and secure the
workpice by the vise to perform the
compound cutting.
IMPORTANT:
Make sure both sliding
fences are secure and tight before
beginning any cutting operation.
Fig. EE
BEVEL CUT (FIG. DD)
1. When a bevel cut is required,
loosen the bevel lock handle for
angle adjusting.
2. Tilt the cutting head to the desired
angle as shown on the bevel scale
(1). The blade can be positioned at
any angle, from a 90° straight cut
(0° on the scale) to a 45° left bevel.
3. Unlock the left sliding fence plate
by loosening the knob, and slide
the plate leftward for avoiding
interference, and tighten the knob.
4. Tighten the bevel lock handle to
lock the cutting head in position.
5. Positive stops are provided at 0°
and 45°.
IMPORTANT:
Make sure both sliding
fences are secure and tight before
beginning any cutting operation.
Fig. DD
COMPOUND CUT (FIG. EE)
A compound cut is the combination of
a miter and a bevel cut simultaneously.
1. Unlock the left sliding fence unit
by unlocking the positive stop lock
lever behind the left sliding fence
unit and lifting up the lock lever
pivotally connected in the base.
2. Slide the left sliding fence unit to the
desired angle from 0°~ 50° forward.
1
