18
19
18
19
●
If you have any problem or question
on the laser guide, please call the
Service Center.
AVOID DIRECT EYE CONTACT
●
Laser is radiated when laser
guide is turned on. Avoid direct
eye contact. Always un-plug the
miter saw from power source
before making any adjustments.
●
Laser Warning Label:
Max output < 5 mW DIODE
Wavelength: 630-660nm,
Complies with 21CFR 1040.10
and 1040. 11. (Fig. X)
●
Laser Aperture Label:
AVOID EXPOSURE: Laser
radiation is emitted from this
aperture. (Fig. X)
●
NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.
THE LASER GUIDE (FIG. W, X, Y)
For your own safety, never connect
the plug to a power source outlet
until all the adjustment steps
are complete and you have read
and understood the safety and
operational instructions.
Your tool is equipped with a laser guide
using a Class IIIa laser guide. The laser
guide allows you to preview the saw
blade path on the workpiece to be cut
before starting the miter saw. This laser
guide is powered by the transformed
alternating current supply directly
through the power lead. The saw must
be connected to the power source and
the laser on/off switch must be turned
on for the laser line to show.
TURNING SAW ON (FIG. W)
1. To turn laser on, turn switch (1) to
“I” position.
2. To turn laser off, turn switch to “O”
position.
Fig. W
NOTE:
●
All the adjustments for the operation
of the laser guide has been
completed at the factory.
●
Laser beam is calibrated and set up to
project to the left of the blade. (Fig. Y)
1
WARNING
!
LASER RADIATION-AVOID
DIRECT EYE EXPOSURE
Complies with 21 CFR 1040.10 and 1040.11
Max.Output <5 mW Wa
velength: 630-660 nm
WARNING
!
WARNING
!
WARNING
!
DANGER
!
