14
15
14
15
NOTE:
Mounting hardware is not
included with this tool. Bolts, nuts,
washers, and screws must be
purchased separately.
2.
For portable use
, place the saw on
a 19 mm thick piece of plywood. Bolt
the base of the miter saw securely
to the plywood using the mounting
holes on the base. Use C-clamps
to clamp this mounting board to a
stable work surface at the worksite.
Fig. J
Fig. K
●
Never carry the miter saw by the
power cord or by the switch handle.
Carrying the tool by the power
cord could cause damage to the
insulation or wire connections
resulting in electric shock or fire.
●
To avoid injury from flying debris, do
not allow visitors to stand behind the
saw.
●
Place the saw on a firm, level work-
surface where there is room for
handling and properly supporting
the workpiece.
●
Support the saw on a level work
surface.
●
Bolt or clamp the saw to its support.
Place the saw in the desired
location, either on a work bench or
recommended leg set. The base of
the saw has three mounting holes
(10). (Fig. J)
Mounting instructions:
1.
For stationary use
, place the saw
in the desired location, directly on
a workbench where there is room
for handling and proper support of
the workpiece. The base of the saw
has three mounting holes. Bolt the
miter saw base (1) to the workbench
(5), using the fastening method as
shown in Fig. I.
Fig. I
10
10
1. Miter saw base
2. Hex head bolt
3. Rubber washer
4. Flat washer
5. Workbench
6. Flat washer
7. Lockwasher
8. Hex nut
9. Jam nut
1
2
3
4
5
6
7
8
9
19 mm
Plywood
