25
EN
BLADE, BLADE GUARD AND RING CLEANING
Unscrew of the knob of the tie screw (1)
( see FIG. n°11 ) to release the blade guard (2).
WARNING: the blade cleaning must be carried out
with metal gloves and a wet cloth.
To clean the blade on the opposite surface, it is ne-
cessary to remove the blade ( see FIG. n°12 ).
The blade is to be removed as follows:
• disassemble the blade cover ( see FIG. n°12 );
• remove (a) the sharpener and open the thickness
blade with the dial knob to make theblade removal
tool (b) adhere to the blade;
• loosen the 3 or 4 screws (f ) (according to the mo-
del) that fi x the blade;
• lean the Plexiglas blade removal tool on the blade
to obtain the coupling of the blade holes with the
two screws (e), turn the blade until it reaches the
correct position;
• tighten the screw (e) not excessively.
WARNING: the blade guard must be cleaned with
hot water and neutral detergent.
CLEANING OF THE SHARPENER
The sharpener cleaning operation is carried out by
rubbing the grinding moles with a brush; the moles
must be placed in the safety position which means
that they must be turned towards the side opposite
to the blade.
CLEANING OF THE DEFLECTOR
The two screws (a) locking the defl ector must be
unscrewed to remove it (see FIG.n°13).
At this stage clean the defl ector with hot water and
neutral detergent.
Fig. 11. Release of the blade guard
Fig. 12. Placing the mask in order to remove
the blade
Fig. 13. View of the deflector