Fault Monitoring
ICL-F series arrays also include Fault Monitoring, a fea-
ture that monitors all the arrays on the network and
reports on their operating condition.
The Fault Monitoring program was installed on your
computer along with BeamWare 2. Locate the Fault
Monitoring icon on your desktop and double click on it to
open the program.
The opening screen will not include any information until
the Fault Monitor has been connected to the network
and has scanned it for arrays.
Open the Options folder (F9 or select Options under the
File pull down menu) and select the Network tab. Then
select the appropriate Com Port to connect the Fault
Monitor to the network and press OK.
The Monitoring tab in the Options folder allows you to
adjust the scan interval time from 5 seconds to 300 sec-
onds. Use the Up and Down arrows to select what you
feel would be an appropriate interval time and press OK.
Pressing the Detect Columns button in the monitoring
window will scan the network for columns and list them
in the window.
Note that the IC-ID and HW-ID numbers are listed for
each of the column modules and that the summary col-
umn on the right side of the screen shows their status as
Unknown and calls your attention to this with a red bar.
At this point, the program hasn’t checked the columns
for faults. It simply detected their presence on the net-
work.
36
IC Live Users Manual, ICL-F & ICL-F-DUAL
All manuals and user guides at all-guides.com
all-guides.com
