3
Assembly of the foot holders
4x foot holder
4x rubber feet
8x cylinder head screw M4x10
Attach the foot holders at the side parts with the threads down
with 2 screws each and turn the rubber feet into the holders.
Assembly of the covers
Remove the protective foil from the stainless steel covers only just before assembly. The adhesive residue particularly
in the area of the edges and embossing can be removed with a rag soaked with alcohol.
Observe sharp edges in these parts. There is a danger of injury at careless handling.
Installation of the rear cover
1x rear cover
1x low-power device combination socket
8x cylinder head screw M4x10
1x cylinder head screw M4x16
6x nut M4
Clip the low-power combination socket into the corresponding
cut-out of the rear cover.
Attach the rear cover to the basic frame with the screws and
nuts as shown:
Use 6 screws with nuts at the side parts and 3 screws centrally
at the bottom plate. Screw the screw M4x16 into the left posi-
tion as shown in the figure.
