Assembly of the drive motor
1x actuator
1x Y-plate
3x cylinder head screw M3x12
1x countersunk screw M3x12
Attach the actuator to the Y-plate with the 3 cylinder head
screws and the countersunk screw as shown in the figure.
Use the countersunk screw for the countersunk bore.
Apply screws with threadlocker varnish.
The cable exit at the motor must point to the middle of the Y-
plate (i.e. in the figure backwards).
Assembly of the drag chain end piece top
1x drag chain end piece with nipple
1x holding block for guide rail
2x cylinder head screw M3x16
2x countersunk screw M3x8
Attach the drag chain end piece with the countersunk screws
at the holding block.
Attach the holding block with the cylinder head screws as
shown in the figure on the grooved side of the Y-plate.
