38
Installation of the operating cover
Insert the operating cover into the basic mechanics as shown
and attach it with the screws as shown.
8 screws with nuts at the side parts
Use 3 screws centrally at the bottom plate, including screw
M4x16 in the middle position as shown on the screen.
Observe that the operating cover and rear cover meet in the
middle of the device (see arrows) and do not overlap or form
a gap.
Preparation of the sight protection blinds
1x sight protection blind right
1x sight protection blind left
1x LED strip with long connection line
1x LED strip with short connection line
Glue LED strip into the sight protection blinds as shown.
Degrease the adhesive areas first. Distance of the LED strips
from the lower edge of the sight protection blinds, approx. 3
cm.
LED strips with long connection line > left sight protection
blind
LED strips with short connection line > right sight protection
blind
Caution:
Observe the position of the connection lines (see figure).
The solder points must not come into contact with the housing
sheet since there may be irreparable damage to the main and
display PCB otherwise. If required, glue a piece of insulating
tape between the soldering points and the housing sheet.
