Renfert 29491050, Translation Of The Original Instructions For Use

Page: 20 / 230

EN
2.5.2 Specific instructions
► Always disconnect the unit from the compressed air and power sources prior to beginning any
maintenance work.
► When working on the tank (filling up, cleaning, maintenance) wear protective glasses for protect -
ing your eyes.
► Any residue of abrasive material on the gasket may lead to leakage and early wear of the gasket.
After filling up clean the thread and the gasket and close the lid properly.
► DO NOT use solvent-containing cleaning agents or disinfectants.
► Solvents and tensides can create micro-cracking in the plastic (danger of explosion!). Clean the
tank and the lid only with a dry cloth. Do not write or stick something on the tanks.
► Do not unscrew the tank lid as long as the pressure had not been released.
► Check the tanks and the lids regularly on damages and replace them in case of doubt.
► Check the tank cover for correct seating prior to beginning operation. Covers that are not secure-
ly closed can suddenly be blown off as the tank pressure increases. The resulting flying parts and
abrasive represent a serious hazard.
► Never operate the blasting units without suitable dust extraction and appropriate protective gear,
as this could result in health hazards. The type of dust extraction should be selected on the basis
of the dust being generated. Follow here absolutely EN 60335-2-69 appendix AA or ask the appro-
priate authorities.
► Improper use can result in the risk of eye or skin injuries.
► Never direct the blasting material towards eyes or unprotected areas of skin!
► Never work with the view screen open!
► Caution: Failure to wear proper eye protection can result in eye injury due to particles suspended
in the air. Always wear proper eye protection to protect your vision!
► Do not employ the foot switch when only the compressed air supply hose is connected. The loose
hose could wrap around itself and cause serious injury.
2.6 Authorised persons
This product may only be used by persons over the age of 14.
Operation and service may only be carried out by trained personnel.
Repairs which are not described in these instructions may only be carried out by skilled electricians and
the specialist dealers.
2.7 Liability exclusion
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions.
► The product is altered in any way other than those alterations described in the operating instruc-
tions.
► The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed.
► The product continues to be employed, despite obvious safety faults.
► In the case of mechanical impact or if the unit is dropped.
- 5 -