M34286T2-CPE User’s Manual
2. Setup
R20UT0214EJ0200 Rev.2.00
Page 32 of 70
Sep 16, 2010
2.8.4 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not.
Figure 2.15 shows the positions of the emulator status LEDs.
Figure 2.15 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs is lit immediately after the power is activated. If it is not lit,
shut off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.16 when the user system is not connected and as shown in Figure 2.17
when a user system is connected. When the self-check is terminated, SAFE LED (LED2) lights on and the target status
LEDs display as shown in Figures 2.16 and 2.17.
When the target status LEDs do not display as shown in Figures 2.16 and 2.17, refer to “Chapter 5. Troubleshooting”
(page 61).
